Academic Journals Database
Disseminating quality controlled scientific knowledge

Comparison of bending stresses for different number of teeth of spur gear obtained using MATLAB Simulink with AGMA and ANSYS

ADD TO MY LIST
 
Author(s): Ishan Patel1 , Dr. M.S. Murthy

Journal: International Journal of Engineering Trends and Technology
ISSN 2231-5381

Volume: 4;
Issue: 7;
Start page: 3141;
Date: 2013;
VIEW PDF   PDF DOWNLOAD PDF   Download PDF Original page

Keywords: Spur gear | Modelling | AGMA | curve fitting | simulink.

ABSTRACT
Spur gears are normally used in every field of engineering where the power transmission is required at moderate speed. The study in this paper shows that the complex design problem of spur gear which requires fine software skill for modelling and also for analysing. The above problem can be resolved by using MATLAB Simulink which provide equivalent results to the AGMA and also to the ANSYS. In this paper we first modelled spur gear in Pro engineer wildfire 5.0 and then calculated the stresses on ANSYS work bench. After that we create a Simulink model using curve fitting equation. The results are compared with both AGMA and ANSYS.

Tango Jona
Tangokurs Rapperswil-Jona

     Save time & money - Smart Internet Solutions