Academic Journals Database
Disseminating quality controlled scientific knowledge

Comparison of Bending Stresses for Different Face Width of Helical Gear Obtained Using Matlab Simulink with AGMA and ANSYS

ADD TO MY LIST
 
Author(s): Pushpendra Kumar Mishra1 , Dr. M.S. Murthy

Journal: International Journal of Engineering Trends and Technology
ISSN 2231-5381

Volume: 4;
Issue: 7;
Start page: 3145;
Date: 2013;
VIEW PDF   PDF DOWNLOAD PDF   Download PDF Original page

Keywords: Helical Gear | Modelling | AGMA | Curve Fitting | Simulink.

ABSTRACT
Helical gears are widely used in industry where the power transmission is required at heavy loads with smoother and noiseless operation. The study in this paper shows that the complex design problem of helical gear requires superior software skills for modelling and analysis. The above problem can be resolved using MATLAB Simulink environment which provides equivalent results to the AGMA and also with ANSYS.In this paper we modelled a helical gear on Pro engineer wildfire 5.0 and stress analysis part is done on ANSYS 12.0. A Simulink model is generated by using curve fitting. The results are compared with both AGMA and FEM procedures.
Affiliate Program     

Tango Jona
Tangokurs Rapperswil-Jona