Academic Journals Database
Disseminating quality controlled scientific knowledge

Comparison of three multitrait methods for QTL detection

ADD TO MY LIST
 
Author(s): Gilbert Hélène | Le Roy Pascale

Journal: Genetics Selection Evolution
ISSN 0999-193X

Volume: 35;
Issue: 3;
Start page: 281;
Date: 2003;
Original page

Keywords: multitrait | QTL | sib families | simulations

ABSTRACT
Abstract A comparison of power and accuracy of estimation of position and QTL effects of three multitrait methods and one single trait method for QTL detection was carried out on simulated data, taking into account the mixture of full and half-sib families. One multitrait method was based on a multivariate function as the penetrance function (MV). The two other multitrait methods were based on univariate analysis of linear combination(s) (LC) of the traits. One was obtained by a principal component analysis (PCA) performed on the phenotypic data. The second was based on a discriminate analysis (DA). It calculates a LC of the traits at each position, maximising the ratio between the genetic and the residual variabilities due to the putative QTL. Due to its number of parameters, MV was less powerful and accurate than the other methods. In general, DA better detected QTL, but it had lower accuracy for the QTL effect estimation when the detection power was low, due to higher bias than the other methods. In this case, PCA was better. Otherwise, PCA was slightly less powerful and accurate than DA. Compared to the single trait method, power can be improved by 30% to 100% with multitrait methods.
Save time & money - Smart Internet Solutions     

Tango Rapperswil
Tango Rapperswil