Author(s): Rodríguez, J. M. | Montecinos, J. | Barrera, L. | Yurac, Y.
Journal: Revista de Metalurgia
ISSN 0034-8570
Volume: 34;
Issue: 1;
Start page: 39;
Date: 1998;
Original page
Keywords: Defects | Continuous casting | Copper | Tubes | Fallas | Colada continua | Tubos | Cobre
ABSTRACT
It has been measured the ratio between the refrigerant flow and the casting speed and the appropriate range of this ratio to avoid the advance or delay of the solidification front has been determined. By means of a variable flow of N2 at the exit zone of the copper tubes the improvement of heat transmission in the mould and of the internal surface quality of the cast tubes was achieved.Se midió la razón entre el flujo del refrigerante y la velocidad de colada y se determinó cuál es el valor apropiado para evitar atrasos o adelantos del frente de solidificación. Por otra parte, mediante un flujo variable de N2 a la salida de los tubos de cobre, se logró mejorar la trasmisión de calor en el molde y mejorar también la calidad interna de los tubos colados.
Journal: Revista de Metalurgia
ISSN 0034-8570
Volume: 34;
Issue: 1;
Start page: 39;
Date: 1998;
Original page
Keywords: Defects | Continuous casting | Copper | Tubes | Fallas | Colada continua | Tubos | Cobre
ABSTRACT
It has been measured the ratio between the refrigerant flow and the casting speed and the appropriate range of this ratio to avoid the advance or delay of the solidification front has been determined. By means of a variable flow of N2 at the exit zone of the copper tubes the improvement of heat transmission in the mould and of the internal surface quality of the cast tubes was achieved.Se midió la razón entre el flujo del refrigerante y la velocidad de colada y se determinó cuál es el valor apropiado para evitar atrasos o adelantos del frente de solidificación. Por otra parte, mediante un flujo variable de N2 a la salida de los tubos de cobre, se logró mejorar la trasmisión de calor en el molde y mejorar también la calidad interna de los tubos colados.