Academic Journals Database
Disseminating quality controlled scientific knowledge

Non primary standards SIM force comparison up to 10 kn

Author(s): Claudia Santo | Jorge Torres Guzman | Daniel Ramírez Ahedo | Juan Ch. Villarroel Poblete

Journal: Innotec
ISSN 1688-3691

Issue: 1;
Date: 2011;
Original page

This force comparison was performed among IDIC (Chile), LATU (Uruguay) and CENAM (Mexico), national laboratories within the Interamerican Metrology System (SIM) region. Each laboratory used its national standard for the established measuring range. The comparison started in August 2002 and finished in September 2004. This comparison is the second part of a SIM primary standards comparison carried out with the participation of INMETRO (Brazil), INTI (Argentina) and SIC (Colombia), having CENAM as pilot laboratory, (SIM comparison number SIM 7.7). This comparison has an overlap with the force steps used in the CIPM Key Comparison CCM.F-K1.a and CCM.F-K1.b., force points 5 kN and 10 kN.The objective of the comparison was to estimate the level of agreement for the realization of the quantity force and the uncertainty associated to its measurement in the range up to 10 kN. Two transducers (load cells) were used as transfer standards, to obtain its maximum accuracy, thecomparison range was selected from 4 kN to 10 kN (starting at 40% of the full load cells range). The results obtained by the participating laboratories were in agreement according to the analysis of comparability performed by the normalized error equation and the Youden plot techniques used.

Tango Jona
Tangokurs Rapperswil-Jona

     Save time & money - Smart Internet Solutions