Academic Journals Database
Disseminating quality controlled scientific knowledge

A New system for Measuring Electrical Conductivity of Water as a Function of Admittance

ADD TO MY LIST
 
Author(s): Haval Yacoob | Susan Shamdeen

Journal: Journal of Electrical Bioimpedance
ISSN 1891-5469

Volume: 2;
Issue: 1;
Start page: 86;
Date: 2011;
Original page

Keywords: Impedance | Admittance | Water conductivity | Four electrode setup

ABSTRACT
This paper presents a new system for measuring water conductivity as a function of electrophysical property (admittance). The system is cheap and its manufacturing is easy. In addition, it dose not require any sort of electrolysis and calibration. The system consists of four electrodes made of silver (Ag 92.5 g to Cu 7.5 g) fixed in a plastic tube filled by water which allows the use of two and four electrode setups. The admittance (reciprocal of impedance) is measured for different water sources (distilled, rainfall, mineral, river and tap water) using different frequencies between 50 Hz and 100 kHz. These measurements were taken twice, once with four electrodes and another with two electrodes of two modes (inner and outer electrodes). The results have shown good correlation between the measured admittance and the conductivity of all the water sources and the best correlation was found at low frequencies between 50 Hz and 20 kHz. The highest efficiency can be achieved by performing the four electrodes system which allows circumventing the effect of the electrode impedance. This result makes the system efficient compared to traditional conductivity meters which usually require high frequencies for good operation. doi:10.5617/jeb.203 J Electr Bioimp, vol. 2, pp. 86-92, 2011
RPA Switzerland

RPA Switzerland

Robotic process automation

    

Tango Rapperswil
Tango Rapperswil